Log 2014061601

Today, I broke through the second mounting bolt on the left side stabilizer bar link of my 2008 Chevy HHR LS.  The last time, I burned up a few Diablo blades on the Sawzall and so I was searching for alternatives today.  Yesterday, I mounted the new left side wheel bearing and in preparation to bleed the brakes, I re-mounted the left side caliper and pads.  So my angle to drill it from wasn't as open today as it was before.

I started using a butane torch today, but several minutes in, I remembed something about the stabilizer bar being made out of tempered steel and promptly quit.  Yesterday, I purchased a drill bit extension from Lowe's in Mentor of Lake County.  But to my chagrin, it only extends 3/8ths drill bits and I was very disappointed.  With the Diablo blades on the Sawzall, I was able cut most of the hex off of the bolt.  But because the blade was so wide, it left a sliver of the hex still on there.  So, I mounted a metal cutting blade of standard width and was able to slice it off without damaging the stabilizer bar.

Afterwards, I took off the right fender.  It was just a series of bolts.  But to my chagrin, the after market replacement fender came with it's own eye socket wielded to it.  Now, I have an extra.  But the replacement didn't come with any insulation.  I'm thinking that I might be able to reuse the one from the old fender.  As for installing, I've decided that I'm going to "sleep on it."  Considering the amount of bolts it and the under shielding has, I'm wondering if that is going to be a mistake?

I was about the bleed the left front caliper solo today, but didn't have a clear tube big enough to fit around the bleeding nut.  And I'm concerned about no doing it right, so either I need a vacuum bleeding kit, or I should just task it out to the mechanic?  I think I'm going to go with the latter. Because right now, I'm at a loss as to where the manual transaxle "check/fill" nut is.  I think its to the left of the fuse block and has a hex key that is identical to the drain plug.

With all that being said, there'a bald spot on the table where I layout all of my new auto parts now.

Log 2014060701

I repadded my cycling helmet today. And the SC Delco manual transaxle fluid for my car came in the mail today. Otherwise, I took my utility hauling trailer to my relatives house today and loaded up some yard waste, but with the license plate light still being out, it was too late to haul it to the recycler.

My automotive repair tasks have been prioritized. And I just started the list for the trailer rails upgrade. I found that the back door would have to be 48in tall to act as a ramp itself.  That is unacceptable because it would be taller than the car and act as a wall when the caravan is in motion.  I, instead, opted to build the rails to 3ft tall and install slots on the outsides so that they transport four ramps of 1" x 6" that are 6' long. They'll have slots on the back door and together, they should make a 6' ramp. The tool bay has wheels. And it's the heaviest thing that I transport. It's probably over 300lbs and is the hardest thing to load and unload.  Last year, I avoided doing it at all costs.

I wanted to get some front bars mounted like you would see on the front of a police interceptor.  If it's legal, I could mount a 5,000lb wench.  My Chevy HHR and trailer are about 4,600lbs together and if I ever got stuck, I could just get myself out. But finding this for a car, and not a truck is difficult. So, these items are not essential to me at the moment are a "would be nice" item.